CCNP mcq questions with answer – Set 3

Important Instructions:

• Total Number Of Questions : 10
• Passing Marks : 7
• Each Question Carry 1 Mark, No Negative Marking.
• Do Not Refresh The Page.
• This Is A FREE Online Test, DO NOT Pay Money To Anyone To Attend This Test.
• Best Of Luck…

Results

-

Congratulation…
You Have Passed The Test, You Should Try To The Next One…!!

Rate this post

You May Also Like :   CCNP mcq questions with answer - Set 4

Unfortunately…
You Did Not Pass. Why Not Try It Again?

Rate this post

You May Also Like :   CCNP mcq questions with answer - Set 7

#1. Which of the following best describes traffic between a database server and a web server?

North-South

North-South

East-West

East-West

Client-server

Client-server

Intra-VLAN

Intra-VLAN

#2. Which of the following best describes traffic between an IP phone and a DNS server?

North-South

North-South

East-West

East-West

Point-to-point

Point-to-point

Inter-VLAN

Inter-VLAN

#3. Which of the following is the most scalable physical architecture for North-South traffic patterns?

Leaf-and-spine architecture

Leaf-and-spine architecture

Two-tier collapsed core

Two-tier collapsed core

Three-tier

Three-tier

Routed

Routed

#4. Which of the following layers should always be routed?

Access

Access

Aggregation

Aggregation

Distribution

Distribution

Core

Core

#5. Which of the following should be in the same distribution block? (Choose two.)

Select all that apply:

Web application load balancer

Web application load balancer

An IP phone

An IP phone

A web server

A web server

An Internet router

An Internet router

#6. Which of the following is true regarding a routed interface on a switch?

It must be assigned an IP address.

It must be assigned an IP address.

It consumes one VLAN.

It consumes one VLAN.

It can be configured as a trunk port.

It can be configured as a trunk port.

It can be assigned two IP addresses.

It can be assigned two IP addresses.

#7. Which of the following layer 2 topologies let you span a VLAN across more than two switches? (Choose two.)

Select all that apply:

You May Also Like :   CCNP mcq questions with answer - Set 8

Looped

Looped

Loop-free U

Loop-free U

Loop-free inverted-U

Loop-free inverted-U

Routed

Routed

#8. Which of the following is true of using a VSS topology?

You should disable Spanning Tree when using VSS.

You should disable Spanning Tree when using VSS.

There's no need to run a FHRP.

There's no need to run a FHRP.

Access switches must connect to the virtual switch using multichassis EtherChannels.

Access switches must connect to the virtual switch using multichassis EtherChannels.

The active and standby both perform IP routing to avoid asymmetric routing.

The active and standby both perform IP routing to avoid asymmetric routing.

#9. Given two distribution switches and one VLAN that spans four access switches, which layer 2 topology will consume the fewest number of ports on the distribution switches?

Looped triangle

Looped triangle

Looped square

Looped square

Routed

Routed

Loop-free U

Loop-free U

#10. What are two differences between the VSS topology and the looped triangle? (Choose two.)

Select all that apply:

The looped triangle can't use EtherChannels.

The looped triangle can't use EtherChannels.

The looped triangle has blocked links.

The looped triangle has blocked links.

The VSS requires access switches to be directly connected to one another.

The VSS requires access switches to be directly connected to one another.

The VSS has no links blocking.

The VSS has no links blocking.

CHECK ANSWER