CCNA MCQ Quiz and Online Test

Important Instructions:

Total Number Of Questions : 10
Passing Marks : 7
Each Question Carry 1 Mark, No Negative Marking.
Do Not Refresh The Page.
This Is A FREE Online Test, DO NOT Pay Money To Anyone To Attend This Test.
Best Of Luck…

Results

Congratulation…
You Have Passed The Test, You Should Try To The Next One…!!

Rate this post

Unfortunately…
You Did Not Pass. Why Not Try It Again?

Rate this post

#1. Network 206.143.5.0 was assigned to the Acme Company to connect to its ISP. The administrator of Acme would like to configure one router with the commands to access the Internet. Which commands could be configured on the Gateway router to allow Internet access to the entire network? (Choose two.)

#2. What command is used to stop RIP routing updates from exiting out an interface but still receive RIP route updates?

Router(config-if)#no routing

Router(config-if)#passive-interface

Router(config-router)#passive-interface s0

Router(config-router)#no routing updates

#3. Which of the following statements are true regarding the command ip route 172.16.4.0 255.255.255.0 192.168.4.2? (Choose two.)

Select all that apply:

The command is used to establish a static route.

The default administrative distance is used.

The command is used to configure the default route.

The subnet mask for the source address is 255.255.255.0.

The command is used to establish a stub network.

#4. What destination addresses will be used by Host_A to send data to the HTTPS server as shown in the graphic above? (Choose two.)

The IP address of the switch

The MAC address of the remote switch

The IP address of the HTTPS server

The MAC address of the HTTPS server

The IP address of RouterA’s Fa0/0 interface

The MAC address of RouterA’s Fa0/0 interface

#5. Which of the following is true regarding the above output? (Choose two.)

Select all that apply:

There are three interfaces on the router participating in this update.

A ping to 192.168.50.1 will be successful.

There are at least two routers exchanging information.

A ping to 192.168.40.2 will be successful.

#6. What is split horizon?

Information about a route should not be sent back in the direction from which the original update came.

It splits the traffic when you have a large bus (horizon) physical network.

It holds the regular updates from broadcasting to a downed link.

It prevents regular update messages from reinstating a route that has gone down.

#7. According to the above graphic, which of the following would be true if HostA is trying to communicate to HostC and interface Fa0/0 of Router C goes down? (Choose two.)

Select all that apply:

RouterC will use an ICMP to inform HostA that HostB cannot be reached.

RouterC will use ICMP to inform RouterB that HostB cannot be reached.

RouterC will use ICMP to inform HostA, RouterA, and RouterB that HostB cannot be reached.

RouterC will send a Destination Unreachable message type.

#8. Which statement is true regarding classless routing protocols? (Choose two.)

Select all that apply:

The use of discontiguous networks is not allowed.

The use of variable length subnet masks is permitted.

RIPv2 supports classless routing.

IGRP supports classless routing within the same autonomous system.

#9. Which two of the following are true regarding the distance-vector and link-state routing protocols?

Link state sends its complete routing table out all active interfaces on periodic time intervals.

Distance vector sends its complete routing table out all active interfaces on periodic time intervals.

Link state sends updates containing the state of their own links to all routers in the internetwork.

Distance vector sends updates containing the state of their own links to all routers in the internetwork.

#10. Which command displays RIP routing updates?

show ip route

debug ip rip

show protocols

debug ip route

CHECK ANSWER

Rate this post