CCNA mcq questions with answer – Set 7

Important Instructions:

• Total Number Of Questions : 10
• Passing Marks : 7
• Each Question Carry 1 Mark, No Negative Marking.
• Do Not Refresh The Page.
• This Is A FREE Online Test, DO NOT Pay Money To Anyone To Attend This Test.
• Best Of Luck…

Results

-

Congratulation…
You Have Passed The Test, You Should Try To The Next One…!!

Rate this post

You May Also Like :   CCNA MCQ Online Test

Unfortunately…
You Did Not Pass. Why Not Try It Again?

Rate this post

You May Also Like :   CCNA mcq questions with answer - Set 21

#1. You received a router from your main corporate office and need to configure it to work on your network. You boot the router and notice it has an old configuration on the router. What should you do?

Erase the RAM and reboot the router.

Erase the RAM and reboot the router.

Erase Flash and restart the router.

Erase Flash and restart the router.

Erase NVRAM and restart the router.

Erase NVRAM and restart the router.

Enter and save the new configuration.

Enter and save the new configuration.

#2. Which of the following prompts indicates that you are in privileged mode?

>

>

(config)#

(config)#

#

#

!

!

#3. If you type a command and receive the error % incomplete command from a switch CLI, what would you do to get help?

Type history to review the error.

Type history to review the error.

Re-enter the command followed by a question mark to view the keywords.

Re-enter the command followed by a question mark to view the keywords.

Type help.

Type help.

Enter a question mark to see all of the console commands.

Enter a question mark to see all of the console commands.

#4. Which command will show you whether a DTE or a DCE cable is plugged into serial 0?

sh int s0

sh int s0

sh int serial 0

sh int serial 0

sho controllers s 0

sho controllers s 0

sho serial 0 controllers

sho serial 0 controllers

#5. What keystroke will terminate setup mode?

Ctrl+Z

Ctrl+Z

Ctrl+^

Ctrl+^

Ctrl+C

Ctrl+C

Ctrl+Shift+^

Ctrl+Shift+^

#6. Which of the following commands will display a backup configuration?

sh running-config

sh running-config

show startup-config

show startup-config

show version

show version

show backup-config

show backup-config

#7. Which of the following commands will configure all the default VTY ports on a router?

Router#line vty 0 4

Router#line vty 0 4

Router(config)#line vty 0 4

Router(config)#line vty 0 4

Router(config-if)#line console 0

Router(config-if)#line console 0

Router(config)#line vty all

Router(config)#line vty all

#8. Which of the following commands sets the secret password to “Cisco”?

enable secret password Cisco

enable secret password Cisco

enable secret cisco

enable secret cisco

enable secret Cisco

enable secret Cisco

enable password Cisco

enable password Cisco

#9. If you wanted administrators to see a message when logging into the router, which command would you use?

message banner motd

message banner motd

banner message motd

banner message motd

banner motd

banner motd

message motd

message motd

#10. Which of the following commands will reload the router?

Router>reload

Router>reload

Router#reset

Router#reset

Router#reload

Router#reload

Router(config)#reload

Router(config)#reload

CHECK ANSWER