Important Instructions:
- Total Number Of Questions : 10
- Passing Marks : 7
- Each Question Carry 1 Mark, No Negative Marking.
- Do Not Refresh The Page.
- This Is A FREE Online Test, DO NOT Pay Money To Anyone To Attend This Test.
- Best Of Luck…
Results
-
Congratulation…
You Have Passed The Test, You Should Try To The Next One…!!
Unfortunately…
You Did Not Pass. Why Not Try It Again?
#1. You need to configure a router for a Frame Relay connection to a non-Cisco router. Which of the following commands will prepare the WAN interface of the router for this connection?
#2. The Acme Corporation is implementing dial-up services to enable remote-office employees to connect to the local network. The company uses multiple routed protocols, needs authentication of users connecting to the network, and since some calls will be long distance, needs callback support. Which of the following protocols is the best choice for these remote services?
#3. Which WAN encapsulations can be configured on an asynchronous serial connection? (Choose two.)
Select all that apply:
#4. With regard to ISDN, which of the following are true? (Choose three.)
Select all that apply:
#5. What is the reason why the serial link between the Corp router and the Remote router will not come up?
#6. You have been called in as a highly paid consultant to fix a problem with a small business because the network administrator has left unexpectedly. Your only clue to the network was a diagram as shown in the graphic above. Based on what is shown here, which of the following types of Internet connections might the company have? (Choose two.)
Select all that apply:
#7. A remote site has just been connected to the central office. However, remote users cannot access applications at the central office. The remote router can be pinged from the central office router. After reviewing the command output shown above, which is the most likely reason for the problem?
#8. Calls made from the Corp router to the Remote router are unsuccessful. Looking at the output of the Corp router, what could the problem be?
#9. The output shown above was taken from two directly connected routers. Based on the output of these two routers, which of the following would be displayed when the command Router#show interface serial 0 is entered? (Choose two.)
