Home » CCNA mcq questions with answer – Set 18

CCNA mcq questions with answer – Set 18

Important Instructions:

  • Total Number Of Questions : 10
  • Passing Marks : 7
  • Each Question Carry 1 Mark, No Negative Marking.
  • Do Not Refresh The Page.
  • This Is A FREE Online Test, DO NOT Pay Money To Anyone To Attend This Test.
  • Best Of Luck…

Results

-

Congratulation…
You Have Passed The Test, You Should Try To The Next One…!!

Rate this post
You May Also Like :   CCNA mcq questions with answer - Set 22

Unfortunately…
You Did Not Pass. Why Not Try It Again?

Rate this post
You May Also Like :   CCNA mcq questions with answer - Set 14
Share your score!
Tweet your score!
Share to other

#1. If you want to have more than one Telnet session open at the same time, what keystroke combination would you use?

#2. You are unsuccessful in telnetting into a remote device. What could the problem be? (Choose two.)

Select all that apply:

#3. What information is displayed by the show hosts command? (Choose two.)

Select all that apply:

#4. Which three commands can be used to check LAN connectivity problems on a router?

#5. You telnet to a router and make your necessary changes; now you want to end the Telnet session. What command do you type in?

#6. You telnet into a remote device and type debug ip rip, but no output from the debug command is seen. What could the problem be?

#7. Which command displays the configuration register setting?

#8. You need to gather the IP address of a remote switch that is located in Hawaii. What can you do to find the address?

#9. You have your laptop directly connected into a router’s Ethernet port. Which of the following are among the requirements for the copy flash tftp command to be successful? (Choose three.)

Select all that apply:

You May Also Like :   CCNA mcq questions with answer - Set 19

#10. The configuration register setting of 0x2102 provides what function to a router?

CHECK ANSWER
Rate this post
Scroll to Top