CCNA MCQ Quiz and Online Test

Results

Congratulation…
You Have Passed The Test, You Should Try To The Next One…!!

5/5 - (2 votes)

Unfortunately…
You Did Not Pass. Why Not Try It Again?

5/5 - (2 votes)

#1. Your company is running IGRP using an AS of 10. You want to configure EIGRP on the network, but want to migrate slowly to EIGRP and you do not want to configure redistribution. What command would allow you to migrate over time to EIGRP without configuring redistribution?

router eigrp 11

router eigrp 10

router eigrp 10 redistribute igrp

router igrp combine eigrp 10

#2. Which EIGRP information is held in RAM and maintained through the use of Hello and update packets? (Choose two.)

Select all that apply:

Neighbor table

STP table

Topology table

DUAL table

#3. Which of the following describe the process identifier that is used to run OSPF on a router? (Choose two.)

Select all that apply:

It is locally significant.

It is globally significant.

It is needed to identify a unique instance of an OSPF database.

It is an optional parameter required only if multiple OSPF processes are running on the router.

#4. Where are EIGRP successor routes stored?

In the routing table only

In the neighbour table only

In the routing table and the topology table

In the routing table and neighbour table

#5. Which command will display all the EIGRP feasible successor routes known to a router?

show ip routes *

show ip eigrp summary

show ip eigrp topology

show ip eigrp adjacencies

#6. He tells you he still can’t see any routes in the routing table. What configuration error did the administrator make?

The wildcard mask is incorrect.

The OSPF area is wrong.

The OSPF Process ID is incorrect.

The AS configuration is wrong.

#7. Which of the following protocols support VLSM, summarization, and discontiguous networking? (Choose three.)

Select all that apply:

RIPv1

IGRP

EIGRP

OSPF

BGP

RIPv2

#8. Which of the following are true regarding OSPF areas? (Choose three.)

Select all that apply:

You must have separate loopback interfaces configured in each area.

The numbers you can assign an area go up to 65,535

The backbone area is also called area 0.

If your design is hierarchical, then you don’t need multiple areas.

All areas must connect to area 0.

If you have only one area, it must be called area 1.

#9. Which of the following network types have a designated router and a backup designated router assigned? (Choose two.)

Select all that apply:

Broadcast

Point-to-point

NBMA

NBMA point-to-point

#10. A network administrator needs to configure a router with a distance vector protocol that allows classless routing. Which of the following satisfies those requirements?

IGRP

OSPF

RIPv1

EIGRP

CHECK ANSWER