CCNA MCQ Quiz and Online Test

Important Instructions:

Total Number Of Questions : 10
Passing Marks : 7
Each Question Carry 1 Mark, No Negative Marking.
Do Not Refresh The Page.
This Is A FREE Online Test, DO NOT Pay Money To Anyone To Attend This Test.
Best Of Luck…

Results

Congratulation…
You Have Passed The Test, You Should Try To The Next One…!!

Rate this post

Unfortunately…
You Did Not Pass. Why Not Try It Again?

Rate this post

#1. What does RIPv2 use to prevent routing loops? (Choose two.)

Select all that apply:

CIDR

Split horizon

Authentication

Holddown timers

#2. A network administrator views the output from the show ip route command. A network that is advertised by both RIP and IGRP appears in the routing table flagged as an IGRP route. Why is the RIP route to this network not used in the routing table?

IGRP has a faster update timer.

IGRP has a lower administrative distance.

RIP has a higher metric value for that route.

The IGRP route has fewer hops.

#3. You type debug ip rip on your router console and see that 172.16.10.0 is being advertised to you with a metric of 16. What does this mean?

The route is 16 hops away.

The route has a delay of 16 microseconds.

The route is inaccessible.

The route is queued at 16 messages a second.

#4. IGRP uses which of the following as default parameters for finding the best path to a remote network? (Choose two.)

Select all that apply:

Hop count

MTU

Cumulative interface delay

Path bandwidth value

#5. The corporate router receives an IP packet with a source IP address of 192.168.214.20 and a destination address of 192.168.22.3. Looking at the output from the Corporate router, what will the router do with this packet?

The packets will be discarded.

The packets will be routed out the S0/0 interface.

The router will broadcast looking for the destination.

The packets will be routed out the Fa0/0 interface.

#6. If your routing table has a static, a RIP, and an IGRP route to the same network, which route will be used to route packets by default?

Any available route

RIP route

Static route

IGRP route

#7. You have the above routing table. Which of the following networks will not be placed in the neighbour routing table?

172.16.30.0

192.168.30.0

10.0.0.0

All of them will be placed in the neighbour routing table.

#8. Two connected routers are configured with RIP routing. What will be the result when a router receives a routing update that contains a higher-cost path to a network already in its routing table?

The updated information will be added to the existing routing table.

The update will be ignored and no further action will occur.

The updated information will replace the existing routing table entry.

The existing routing table entry will be deleted from the routing table and all routers will exchange routing updates to reach convergence.

#9. What is route poisoning?

It sends back the protocol received from a router as a poison pill, which stops the regular updates.

It is information received from a router that can’t be sent back to the originating router.

It prevents regular update messages from reinstating a route that has just come up.

It describes when a router sets the metric for a downed link to infinity.

#10. Which of the following is true regarding RIPv2?

It has a lower administrative distance than RIPv1.

It converges faster than RIPv1.

It has the same timers as RIPv1.

It is harder to configure than RIPv1.

CHECK ANSWER

Rate this post