CCNA MCQ Quiz and Online Test

Results

Congratulation…
You Have Passed The Test, You Should Try To The Next One…!!

Rate this post

Unfortunately…
You Did Not Pass. Why Not Try It Again?

Rate this post

#1. You need the IP address of the devices with which the router has established an adjacency. Also, the retransmit interval and the queue counts for the adjacent routers need to be checked. What command will display the required information?

show ip eigrp adjacency

show ip eigrp topology

show ip eigrp interfaces

show ip eigrp neighbors

#2. For some reason, you cannot establish an adjacency relationship on a common Ethernet link between two routers. Looking at the output above, what is the cause of the problem?

The OSPF area is not configured properly.

The priority on RouterA should be set higher.

The cost on RouterA should be set higher.

The Hello and Dead timers are not configured properly.

#3. Which is true regarding EIGRP successor routes? (Choose two.)

Select all that apply:

A successor route is used by EIGRP to forward traffic to a destination.

Successor routes are saved in the topology table to be used if the primary route fails.

Successor routes are flagged as “active” in the routing table.

A successor route may be backed up by a feasible successor route.

#4. Which type of OSPF network will elect a backup designated router? (Choose two.)

Select all that apply:

Broadcast multi-access

Non-broadcast multi-access

Point-to-point

Broadcast multipoint

#5. Which two of the following commands will place network 10.2.3.0/24 into area 0?

Select all that apply:

router eigrp 10

router ospf 10

network 10.2.3.0 0.0.0.255 area 0

network 10.0.0.0

#6. With which network type will OSPF establish router adjacencies but not perform the DR/BDR election process?

Point-to-point

Backbone area 0

Broadcast multiaccess

Non-broadcast multi-access

#7. What are three reasons for creating OSPF in a hierarchical design? (Choose three.)

Select all that apply:

To decrease routing overhead

To speed up convergence

To confine network instability to single areas of the network

To make configuring OSPF easier

#8. What is the administrative distance of OSPF?

100

110

120

#9. You have an internetwork as shown in the graphic above. However, the two networks are not sharing routing table route entries. Which command is needed to fix the problem?

version 2

no auto-summary

redistribute eigrp 10

default-information originate

#10. If routers in a single area are configured with the same priority value, what value does a router use for the OSPF Router ID in the absence of a loopback interface?

The lowest IP address of any physical interface

The highest IP address of any physical interface

The lowest IP address of any logical interface

The highest IP address of any logical interface

CHECK ANSWER